If you make an opening in the ceiling of a fire separating element to install a recessed light fitting you must restore the ceiling's fire-stopping integrity. This is a requirement of both the Building Regulations and the IEE Wiring Regulations 16th Edition.

Installed in Minutes Protects for Life

• Easy to install - flexible one piece unit that can be folded and fitted through the diagonal in the ceiling grid
• Can be fitted in seconds - no fixing clips, frame assembly or additional sealant required
• Self supporting and lightweight - no pre-assembly required
• Pre-made slots for easy location on to ceiling grid
• Designed to fit a wide range of 600 x 600 and 1200 x 600 modular luminaires
• Tested and approved for use on suspended ceilings
• Provides a high level of additional heat insulation to the ceiling void during a fire thus reducing the chances of ignition of accumulated dust and flammable materials
• Specially formulated durable mineral fibre minimises thermal convection
• Easy to remove and re-install for luminaire maintenance
• Reinstates the acoustic protection of the ceiling
• Reduces heat within the room from escaping through the light fitting
• Cable entry points can be made anywhere on the sides and top for ease of wiring the luminaire
• Fibres used are exonerated from classification according to HSE guidelines
• Rot, corrosion and vermin resistant
• Maintenance free
• In excess of 60 minute protection

Available in two sizes that cover a vast range of modular fluorescent luminaires

• AF130/600 for 600 x 600 Module
  Side: 730mm external base 680mm top
  End: 670mm external base 620mm top
  Height: 155mm external
  Weight: 1.75kg approx
• AF130/1200 for 1200 x 600 Module
  Side: 1330mm external base 1280mm top
  End: 700mm external base 650mm top
  Height: 140mm external
  Weight: 2.25kg approx